What it does, and the math it runs
This calculator puts two tire sizes through the same geometry and reports everything that changes between them: diameter, width, sidewall height, circumference, revolutions per mile, speedometer error at real road speeds, and the gearing change that comes along for the ride. It starts by turning a size into a diameter. For a metric size, the sidewall is width × aspect ratio ÷ 25.4, and diameter = rim + two sidewalls. For an inch size, the diameter is printed right on the tire, and the sidewall is (diameter − rim) ÷ 2. From diameter, everything else is derived: circumference = π × diameter, revolutions per mile = 63,360 ÷ circumference (there are 63,360 inches in a mile), and your true speed at any speedometer reading = indicated speed × (new diameter ÷ old diameter).
The gear ratio helper closes the loop. Your recommended new axle ratio = current ratio × (new diameter ÷ old diameter), because gearing has to shrink the same proportion the tire grew. It also shows road speed at your chosen RPM for both sizes, using speed = RPM × diameter × π ÷ (axle ratio × transmission gear × 5,280). One honest limit: a sidewall marking is a nominal size, not a measurement. Two tires both labeled 285/70R18 can differ by a few tenths of an inch between brands, and a loaded tire's effective rolling diameter is slightly less than its unloaded one. The math here is exact for the size as labeled; for a final fitment call, compare it against the manufacturer's published diameter for the specific tire.
How to use it
- Set each panel's format, P-Metric or Inch, to match the size you are entering; the two panels can use different formats.
- Enter your current size on the left and the size you are considering on the right.
- Read the measurements table for the physical differences, then the speedometer table for what your dash will get wrong at each speed.
- Scroll to the gear ratio helper, enter your current axle ratio, a cruise RPM and the transmission gear, and read the recommended ratio that restores your current gearing feel.
Worked example
The page's default comparison, 265/70R18 to 285/70R18, is the classic one-size upgrade. The 265's sidewall is 265 × 0.70 ÷ 25.4 = 7.30 in, for a diameter of 32.61 in and a width of 10.43 in. The 285 grows the sidewall to 7.85 in, the diameter to 33.71 in and the width to 11.22 in: +1.10 in taller, +3.4%. Revolutions per mile fall from about 619 to about 598, and the speedometer error follows the diameter exactly: when the dash says 60 MPH you are actually doing 62.0 MPH. In the gear helper, restoring the stock feel from a 3.73 axle takes 3.73 × 1.034 = a 3.86 ratio, which is why most people leave the gears alone on a one-size bump and save the regear for 35s.